Clamping Mandrel
For clamping hubs / drive flanges.
Article number HD400014
-
Mounting position: vertically suspended
Clamping system SZ
The clamping mandrel is designed for turning and grinding the outer contour and the flat surfaces of the workpiece.
Functional description:
The inner drawbar actuates the double taper collet (SZ system) via a quick-change connection and a clamping bolt. The workpiece lies flat on three fixed contact surfaces during clamping. The outer drawbar actuates the movable end stop via a second quick-change connection and a drawbar. The endstop is designed as a pendulum stop and it adapts to the flat surface of the workpiece to compensate for axial run-out errors.Advantages:- compensation of axial run-out errors through integrated pendulum stop- movable end stop- two clamping points- reduction of set-up times due to quick-change flange connection
- category:
- Clamping Mandrel
- machining:
- grinding, turning
- workpiece:
- hub
- industry:
- commercial vehicles, powertrain
- clamping-Ø:
- 34,00 mm
- connection spindle side:
- short taper 8
- airflow control device:
- direct
- sealing air:
- yes
- clamping tool quick-changeable:
- yes
- fitting position:
- vertically pending
- concentricity at control workpiece :
- 0,010 mm
- outer-Ø:
- 210,00 mm
- overall length:
- 371,00 mm
- weight clamping device:
- 33 kg
- category:
- Clamping Mandrel
- machining:
- grinding, turning
- workpiece:
- hub
- industry:
- commercial vehicles, powertrain
- clamping-Ø:
- 34,00 mm
- connection spindle side:
- short taper 8
- airflow control device:
- direct
- sealing air:
- yes
- clamping tool quick-changeable:
- yes
- fitting position:
- vertically pending
- concentricity at control workpiece :
- 0,010 mm
- outer-Ø:
- 210,00 mm
- overall length:
- 371,00 mm
- weight clamping device:
- 33 kg