Clamping Mandrel
For clamping of rings.
Article number HD400110
-
Mounting position: horizontalClamping system SZ
The clamping mandrel is designed for turning the inner and outer contour of the workpiece.
Functional description:
The clamping for internal machining and face machining is introduced pneumatically via an integrated double piston and is passed on to the collet (system SZ) via a draw piece. The release of clamping is carried out pneumatically as well. The clamping force is reduced via the sealing air and a counter piston to enable machining of the outer contour. In addition, the workpiece is supported by a centring point on the tailstock.
Advantages:
- Double function of the sealing air: additional protection against soiling of the clamping mandrel and reduction of the actuating force by counterpressure on a piston rear side- Turning of the inner and outer contour as well as the flat face with one clamping device can be carried out in two working steps- High-precision clamping of the workpiece
- category:
- Clamping Mandrel
- machining:
- turning
- workpiece:
- ring
- industry:
- hydraulics
- clamping-Ø:
- 6,00 mm
- connection spindle side:
- cylinder ≤ 70
- connection tailstock side:
- MK Morse taper
- sealing air:
- yes
- fitting position:
- horizontal
- repeat accuracy at control workpiece :
- 0,003 mm
- transferable torque:
- 7 Nm
- outer-Ø:
- 120,00 mm
- overall length:
- 294,00 mm
- weight clamping device:
- 12 kg
- material workpiece:
- steel
- category:
- Clamping Mandrel
- machining:
- turning
- workpiece:
- ring
- industry:
- hydraulics
- clamping-Ø:
- 6,00 mm
- connection spindle side:
- cylinder ≤ 70
- connection tailstock side:
- MK Morse taper
- sealing air:
- yes
- fitting position:
- horizontal
- repeat accuracy at control workpiece :
- 0,003 mm
- transferable torque:
- 7 Nm
- outer-Ø:
- 120,00 mm
- overall length:
- 294,00 mm
- weight clamping device:
- 12 kg
- material workpiece:
- steel