Clamping Chuck

For clamping planetary carriers.

Article number HD400066

  • Mounting position: horizontal
    Mounting position: vertically upright
    Clamping system SG

The clamping chuck is designed for milling (finishing) the outer contour of the workpiece.

Functional description:

The clamping is initiated hydraulically and is passed on to the clamping bush (system SG / SZ) via an integrated piston. The workpiece is clamped on two different clamping diameters. The stop surface of the workpiece is located directly on the clamping diameter. For this purpose, the clamping bush (system SG/SZ) is interrupted at three segments to enable a 3-point end stop. The workpiece is clamped in a position-aligned manner by means of lozenge bolts and supported by hydraulically movable support elements on the outer collar. The release of clamping is always initiated hydraulically.

Advantages:

- dual function: segmented face end stop with air system control and workpiece clamping realised side by side in the same area
- hydraulic support elements dampen vibrations and support against machining forces
- two independent contracting clamping points for accurate and repeatable workpiece alignment
- optimised chip removal due to large openings in the bottom of the clamping device
- clamping of different workpiece sizes through exchangeable clamping elements

category:
Clamping Chuck
machining:
drill, milling
workpiece:
shaft
industry:
transmission
clamping-Ø:
70,00 mm / 85,00 mm
connection spindle side:
face location
airflow control device:
direct
sealing air:
yes
fitting position:
horizontal, vertically upright
repeat accuracy at control workpiece :
0,020 mm
transferable torque:
370 Nm
outer-Ø:
320,00 mm
overall length:
290,00 mm
weight clamping device:
101 kg
weight workpiece:
22 kg
material workpiece:
steel
Technical details
category:
Clamping Chuck
machining:
drill, milling
workpiece:
shaft
industry:
transmission
clamping-Ø:
70,00 mm / 85,00 mm
connection spindle side:
face location
airflow control device:
direct
sealing air:
yes
fitting position:
horizontal, vertically upright
repeat accuracy at control workpiece :
0,020 mm
transferable torque:
370 Nm
outer-Ø:
320,00 mm
overall length:
290,00 mm
weight clamping device:
101 kg
weight workpiece:
22 kg
material workpiece:
steel
category
Clamping Chuck
machining
drill, milling
workpiece
shaft
industry
transmission
clamping-Ø
70,00 mm / 85,00 mm
connection spindle side
face location
airflow control device
direct
sealing air
yes
fitting position
horizontal, vertically upright
repeat accuracy at control workpiece
0,020 mm
transferable torque
370 Nm
outer-Ø
320,00 mm
overall length
290,00 mm
weight clamping device
101 kg
weight workpiece
22 kg
material workpiece
steel