Clamping Chuck
For clamping planetary carriers.
Article number HD400066
-
Mounting position: horizontalMounting position: vertically uprightClamping system SG
The clamping chuck is designed for milling (finishing) the outer contour of the workpiece.
Functional description:
The clamping is initiated hydraulically and is passed on to the clamping bush (system SG / SZ) via an integrated piston. The workpiece is clamped on two different clamping diameters. The stop surface of the workpiece is located directly on the clamping diameter. For this purpose, the clamping bush (system SG/SZ) is interrupted at three segments to enable a 3-point end stop. The workpiece is clamped in a position-aligned manner by means of lozenge bolts and supported by hydraulically movable support elements on the outer collar. The release of clamping is always initiated hydraulically.
Advantages:
- dual function: segmented face end stop with air system control and workpiece clamping realised side by side in the same area- hydraulic support elements dampen vibrations and support against machining forces- two independent contracting clamping points for accurate and repeatable workpiece alignment- optimised chip removal due to large openings in the bottom of the clamping device- clamping of different workpiece sizes through exchangeable clamping elements
- category:
- Clamping Chuck
- machining:
- drill, milling
- workpiece:
- shaft
- industry:
- transmission
- clamping-Ø:
- 70,00 mm / 85,00 mm
- connection spindle side:
- face location
- airflow control device:
- direct
- sealing air:
- yes
- fitting position:
- horizontal, vertically upright
- repeat accuracy at control workpiece :
- 0,020 mm
- transferable torque:
- 370 Nm
- outer-Ø:
- 320,00 mm
- overall length:
- 290,00 mm
- weight clamping device:
- 101 kg
- weight workpiece:
- 22 kg
- material workpiece:
- steel
- category:
- Clamping Chuck
- machining:
- drill, milling
- workpiece:
- shaft
- industry:
- transmission
- clamping-Ø:
- 70,00 mm / 85,00 mm
- connection spindle side:
- face location
- airflow control device:
- direct
- sealing air:
- yes
- fitting position:
- horizontal, vertically upright
- repeat accuracy at control workpiece :
- 0,020 mm
- transferable torque:
- 370 Nm
- outer-Ø:
- 320,00 mm
- overall length:
- 290,00 mm
- weight clamping device:
- 101 kg
- weight workpiece:
- 22 kg
- material workpiece:
- steel