Clamping Chuck
For clamping toothed rings.
Article number HD400019
-
_Web_Einbaulage_vertikal_stehend.svg)
Mounting position: vertically upright
_Web_Spannsystem_SZ.svg)
Clamping system SZ
_Web_Spannsystem_SG.svg)
Clamping system SG
The clamping chuck is designed for machining the internal gearing of the workpiece.
Functional description:
Clamping is initiated by an EMUGE force transmission element by means of manual torque. This transmits the force to the clamping bush (system SG / SZ) via a draw piece. Clamping takes place in two planes. A two-part intermediate sleeve must be fitted to the workpiece before loading, as the clamping diameter is offset centrally. This means that the two clamping planes are directly above the gearing of the workpiece. Alignment takes place via a spring-loaded pin.
Advantages:
- optimum clamping in two planes directly above the gearing of the workpiece.- connection of the off-set clamping diameter by means of an intermediate sleeve.
- category:
- Clamping Chuck
- machining:
- toothing
- workpiece:
- ring
- industry:
- aviation, toothing
- clamping-Ø:
- 266,00 mm
- connection spindle side:
- cylinder ≤ 110
- fitting position:
- vertically upright
- concentricity at control workpiece :
- 0,010 mm
- transferable torque:
- 600 Nm
- outer-Ø:
- 400,00 mm
- overall length:
- 308,00 mm
- weight clamping device:
- 140 kg
- weight workpiece:
- 4,5 kg
- material workpiece:
- steel
- category:
- Clamping Chuck
- machining:
- toothing
- workpiece:
- ring
- industry:
- aviation, toothing
- clamping-Ø:
- 266,00 mm
- connection spindle side:
- cylinder ≤ 110
- fitting position:
- vertically upright
- concentricity at control workpiece :
- 0,010 mm
- transferable torque:
- 600 Nm
- outer-Ø:
- 400,00 mm
- overall length:
- 308,00 mm
- weight clamping device:
- 140 kg
- weight workpiece:
- 4,5 kg
- material workpiece:
- steel