Clamping Chuck
For clamping axle journals / joint housings.
Article number HD400007
-
_Web_Einbaulage_vertikal_haengend.svg)
Mounting position: vertically suspended
_Web_Spannsystem_SG.svg)
Clamping system SG
The clamping chuck is designed for a turning and milling operation of the workpiece.
Functional description:
Clamping is initiated via a drawbar on the machine side and, after exceeding the idle stroke, is passed on to the clamping bush (system SG) via a connecting piece. This clamping bush is designed for two different clamping diameters by means of a stepped shoulder. The contact surface at the end stop varies depending on the workpiece. The clamping range is very narrow for both clamping diameters.
Advantages:
- optimum clamping despite very narrow clamping area- use for two different clamping diameters with only one clamping bush
- category:
- Clamping Chuck
- machining:
- milling, turning
- workpiece:
- housing, shaft
- industry:
- powertrain
- clamping-Ø:
- 59,00 mm / 76,00 mm
- connection spindle side:
- cylinder ≤ 170
- airflow control device:
- direct
- sealing air:
- yes
- fitting position:
- vertically pending
- concentricity at control workpiece :
- 0,010 mm
- transferable torque:
- 120 Nm
- outer-Ø:
- 205,00 mm
- overall length:
- 313,00 mm
- weight clamping device:
- 34 kg
- weight workpiece:
- 0,9 kg
- material workpiece:
- steel
- category:
- Clamping Chuck
- machining:
- milling, turning
- workpiece:
- housing, shaft
- industry:
- powertrain
- clamping-Ø:
- 59,00 mm / 76,00 mm
- connection spindle side:
- cylinder ≤ 170
- airflow control device:
- direct
- sealing air:
- yes
- fitting position:
- vertically pending
- concentricity at control workpiece :
- 0,010 mm
- transferable torque:
- 120 Nm
- outer-Ø:
- 205,00 mm
- overall length:
- 313,00 mm
- weight clamping device:
- 34 kg
- weight workpiece:
- 0,9 kg
- material workpiece:
- steel