Clamping Chuck

For clamping toothed rings.

Article number HD400019

  • Mounting position: vertically upright
    Clamping system SZ
    Clamping system SG
H400019_Spannmittel
H400019_Spannmittel_Schnitt
H400019_Werkstueck
    H400019_Spannmittel
    H400019_Spannmittel_Schnitt
    H400019_Werkstueck
    3D

The clamping chuck is designed for slotting the internal gearing of the workpiece.

Functional description:

Clamping is initiated by an EMUGE force transmission element by means of manual torque. This transmits the force to the clamping bush (system SG / SZ) via a draw piece. Clamping takes place in two planes. A two-part intermediate sleeve must be fitted to the workpiece before loading, as the clamping diameter is offset centrally. This means that the two clamping planes are directly above the gearing of the workpiece. Alignment takes place via a spring-loaded pin.

Advantages:

- optimum clamping in two planes directly above the gearing of the workpiece.
- connection of the off-set clamping diameter by means of an intermediate sleeve.

category:
Clamping Chuck
machining:
toothing
workpiece:
ring
industry:
aviation, toothing
clamping-Ø:
266,00 mm
connection spindle side:
cylinder ≤ 110
fitting position:
vertically upright
concentricity at control workpiece :
0,010 mm
transferable torque:
600 Nm
outer-Ø:
400,00 mm
total length:
308,00 mm
weight clamping device:
140 kg
weight workpiece:
4,5 kg
material workpiece:
steel
Technical details
category:
Clamping Chuck
machining:
toothing
workpiece:
ring
industry:
aviation, toothing
clamping-Ø:
266,00 mm
connection spindle side:
cylinder ≤ 110
fitting position:
vertically upright
concentricity at control workpiece :
0,010 mm
transferable torque:
600 Nm
outer-Ø:
400,00 mm
total length:
308,00 mm
weight clamping device:
140 kg
weight workpiece:
4,5 kg
material workpiece:
steel
category
Clamping Chuck
machining
toothing
workpiece
ring
industry
aviation, toothing
clamping-Ø
266,00 mm
connection spindle side
cylinder ≤ 110
fitting position
vertically upright
concentricity at control workpiece
0,010 mm
transferable torque
600 Nm
outer-Ø
400,00 mm
total length
308,00 mm
weight clamping device
140 kg
weight workpiece
4,5 kg
material workpiece
steel
show all

Downloads to the product

There are no downloads for this product.