Stationary clamping device
For clamping of connecting rods.
Article number HD400077
-
Mounting position: vertically uprightClamping system SZ
The stationary clamping device is designed for a milling operation of flat faces on the workpiece.
Functional description:
The workpiece is centred via integrated pressure springs. Clamping is initiated hydraulically and is passed on to the collets (system SZ) via a clamping bolt / via a drawbar. A support device is provided near the fixed stop to facilitate correct loading of the workpiece. The clamping mandrel for the small clamping diameter is adjustable to two different lengths per workpiece. Bolts are installed to lock the respective length of the workpiece. Since the clamping units are adjustable, two workpieces can be machined at the same time. The entire clamping device is mounted on a swivelling machine table.
Advantages:
- The distance between clamping units with small and large piston eyes is adjustable by means of a fixing bolt for use with two workpieces of different lengths.- Machining OP10 and OP20 with one clamping device by means of collets with different modes of operation.
- category:
- Stationary clamping device
- machining:
- milling
- industry:
- engine
- clamping-Ø:
- 23,00 mm / 55,00 mm
- connection spindle side:
- zero-point clamping
- airflow control device:
- direct
- sealing air:
- yes
- fitting position:
- vertically upright
- overall width:
- 290,00 mm
- overall length:
- 856,00 mm
- weight clamping device:
- 217 kg
- weight workpiece:
- 0,7 kg
- material workpiece:
- cast steel
- category:
- Stationary clamping device
- machining:
- milling
- industry:
- engine
- clamping-Ø:
- 23,00 mm / 55,00 mm
- connection spindle side:
- zero-point clamping
- airflow control device:
- direct
- sealing air:
- yes
- fitting position:
- vertically upright
- overall width:
- 290,00 mm
- overall length:
- 856,00 mm
- weight clamping device:
- 217 kg
- weight workpiece:
- 0,7 kg
- material workpiece:
- cast steel